User`s guide

XR200-485 User Menu 33
Service Request
Your user code profile may be programmed for Service Request.
This feature of the User Menu allows you to just press any top row
Select key while SERVICE REQUEST? is displayed and have the
system automatically send a "Request for Service" message to the
central station. The display changes to REQUEST MADE
momentarily to confirm your request was sent.
Fire Drill
Fire Drill is used to test the fire bells or fire horns in your system.
The Fire Drill test turns on your system bell circuit, but does not
send a message to the central station.
Starting a Fire Drill test
1. Access the User Menu.
2. Press COMMAND until the FIRE DRILL? displays. Press any Select
key.
3. The keypad displays SURE? YES NO.
4. Press the Select key under YES to start the Fire Drill test.
Ending a Fire Drill test
1. Enter your code at the keypad and press COMMAND to end the
Fire Drill.
2. The Fire Drill test will automatically end with an ALARM
SILENCE or the programmed Bell Cutoff time.