User`s guide

10 XR200-485 Arming/Disarming

General Disarming Operation

While the system is armed, you can only enter the premises

through an entry/exit delay door without causing an alarm. After

opening the door, the Security Command keypad sounds a

prewarn tone to remind you to disarm the system. (See Door

Access Disarming below.) You must disarm the system before the

entry delay time expires or an alarm on the door zone will occur.

During the entry delay time, the keypad displays ENTER CODE:.

Enter your code to disarm the system. Only those areas assigned

to your code will disarm.

When you present your card to an outside reader to gain access

and your code has authority to disarm, those areas assigned to the

door which match areas assigned to your code will automatically

disarm. Enter code is not displayed.

Schedules: If you have programmed schedules for your system and

a code is entered outside of a schedule and that code does not

have authorization to disarm outside of schedules, the keypad

displays INVALID TIME. This lets the users know that they are

disarming outside of their authorized time. If your system is

monitored, an Unauthorized Entry report is sent to the central

station.

All or Selective Disarming: After entering your user code, the

system allows you to disarm either all of the areas to which you

have access or just selected areas. If you choose to disarm all

areas, the system automatically disarms them. If you choose to

disarm selected areas, the area names will be displayed on the

keypad.

Alarm Display: After disarming, the keypad displays any zones that

tripped or any transmission problems that occurred during the

armed period. All burglary zones are then disarmed and any

bypassed zones are automatically reset.

Disarmed Message: The keypad displays ALL SYSTEM OFF after the

system disarms.

Central Station Report: A report of the system disarming can be

transmitted to the central station. This is optional and can be

programmed for you at any time.

Door Access Disarming: Your system may be programmed to allow

disarming of areas when a card is presented to a door access

reader located outside of the building. Simply present your card

to the reader and after the card’s code is validated for the

appropriate authority, a door access is granted and your matching

areas are automatically disarmed. See the Easy Entry

User’s

Guide in Appendix C.