Programming instructions

3
2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282
XR200 Programming Guide
1 - INTRODUCTION
During programming, the SELECT keys also allow you to change information currently in the panel's memory by
pressing the appropriate SELECT key under the display then entering the new information through the keypad.
When there are more than four response options available, pressing the COMMAND key brings up the next 1 to 4
options on the keypad display. Pressing the ARROW key allows you to review the previous four choices.
The SELECT keys are also used for selecting a section from the programming menu by pressing any one of the
SELECT keys when the name of the programming section you want is displayed.
1.7 Entering Alpha Characters
Some options during programming require you to enter alpha characters. To enter an alpha character, press the key
that has that letter written below it. The keypad displays the number digit of the key. Next, press the SELECT key that
corresponds to the location of the letter under the key. Pressing a different SELECT key changes the letter. When
another digit key is pressed, the last letter displayed is retained and the process is started over.
1.8 Entering non-Alpha Characters
To enter a space in an alpha entry, press the 9 digit key followed by the third SELECT key. The three characters on
the 9 digit key are Y, Z, and space. You can also enter the following characters: – (dash), . (period), * (asterisk), and #
(pound sign) using the zero key and the four SELECT keys from left to right. For example, to enter a – (dash), press
the zero key and then the left SELECT key. A dash now appears in the keypad display.
1.9 Keypad Prompts Display Current Programming
Each programming prompt displayed at the keypad shows the currently selected option in the panel's memory. These
options are either shown as a number, a blank, or a NO or YES. To change a number or blank to a new number,
press any top row SELECT key. The current option is replaced with a dash. Press the number(s) on the keypad you
want to enter as the new number for that prompt.
It is not necessary to enter numbers with leading zeros. The XR200 automatically right justifies the number when you
press the COMMAND key.
To change a programming prompt that requires a NO or YES response, press the top row SELECT key under the
response not selected.
For example, if the current prompt is selected as YES and you want to change it to NO, press the third top row
SELECT key. The display changes to NO. Press the COMMAND key to go to the next prompt. See Figure 4.
BELL TST YES
Press the top row select key.
BELL TST NO
The keypad display changes to the newly
selected option. Press COMMAND.
NEXT
Figure 4: Changing the current option selected.
Figure 3: Keypad display and top row keys
Center CharacterLeft Character Right Character
S Y S T E M O N