Programming instructions

1
2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282
XR200 Programming Guide
1.1 Before you begin
About this guide
This guide provides programming information for the DMP XR200 Command Processor™ Panel. After this
Introduction, the remaining sections describe the functions of each programming menu item along with the available
options. Before starting to program, we recommend you read through the contents of this guide. The information
contained here allows you to quickly learn the programming options and operational capabilities of the XR200 panel.
In addition to this guide, you should also read and be familiar with the following XR200 documents:
• XR200 Installation Guide (LT-0197)
• XR200 Product Specification (LT-0198)
• XR200 Security Command
®
User's Guide (LT-0287)
Internal Programmer
The XR200 contains all of its programming information in an on-board processor and does not require an external
programmer. You can perform all programming tasks through a DMP alphanumeric keypad set to address one.
Programming Information Sheet
Included with each XR200 panel are the Programming Information Sheets. These list the various programming
prompts and available options for programming the panel. Before starting to program, we recommend you completely
fill out each sheet with the programming options you intend to enter into the panel.
Having completed programming sheets available while entering data helps prevent errors and can shorten the time
you spend programming. Completed sheets also provide you with an accurate record of the panel's program you can
keep on file for future system service or expansion. The remainder of this Introduction provides instructions for
starting and ending a XR200 programming session using the alphanumeric keypad.
1.2 Getting Started
Before starting to program the XR200 panel, make sure the panel is properly grounded and AC and battery power is
applied to the appropriate panel terminals. All wiring connections and grounding instructions are detailed in the
XR200 Installation Guide (LT-0197).
Accessing the Programmer
1. Install the reset jumper across the two J16 reset pins
for two seconds. See Figure 1.
2. Remove the reset jumper and place it over just one
pin for future use.
3. Enter the code 6653 (PROG) into an alphanumeric
keypad set to address one. Press COMMAND.
4. The keypad displays: PROGRAMMER.
You are now ready to start programming the XR200 panel.
Pressing the COMMAND key scrolls you through the
programming functions listed in section 1.3. Each of these functions are described in detail in sections 2 to 15.
Initializing the Panel
After installing the XR200, use the Initialization function to set to defaults the panel's programming. Note: The
default user code is 99. This should be changed by the owner as soon as the system is operational.
1.3 Programmer Operation
There are 14 programming sections to choose from:
Menu Item Section Menu Item Section
Initialization 2 Menu Display 9
Communication 3 Status List 10
Device Setup 4 Printer Reports 11
Remote Options 5 Area Information 12
System Reports 6 Zone Information 13
System Options 7 Stop 14
Output Options 8 Set Lockout Code 15
1 - INTRODUCTION
Figure 1: Installing the reset jumper on J16
J16
J16
Command Processor Reset
AC
1
234
56
78
10 11 12
13
14
15
16
17
18
19
AC +B -B
BELL
GND SMK
GND
9
RED
YEL GRN BLK
20
21
22 23 24 25
26
27 28
L1 L2
GND
GND
GND
GND
L3
L4 L5 L6 L7 L8 L9- L9+ L10- L10+