Programming instructions

13
2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282
XR200 Programming Guide
5.8 REMOTE PHONE NUMBER
Press COMMAND to enter the phone number the panel dials whenever remote programming
is requested. After entering a phone number, the panel allows remote commands and
programming only after it has first been called by the authorized receiver, disconnected itself,
and has redialed the remote phone number.
Note: When the function 984 + COMMAND is entered at the keypad, a remote options menu
appears. This menu contains the following options:
NUMBER - The panel allows you to enter into the keypad a phone number you want the
panel to dial. Enter any required prefixes and area codes.
REMOTE - The panel dials the phone number programmed in Remote Phone Number. See
section 5.8.
PICKUP - The panel picks up the phone line as Remote Access™ calls in. The phone must
be ringing before selecting PICKUP. If a Remote Phone Number is NOT entered, and Alarm
Receiver and Service Receiver is YES the panel allows remote commands and programming
without disconnecting and redialing. The phone number can be up to 15 digits in length. Enter
a D for dial tone detect and a P for a 3 second pause.
5.9 REMOTE DISARM
YES allows the panel to be disarmed remotely. NO disables remote disarming.
6.1 SYSTEM REPORTS
This section allows you to select specific system reports the XR200 sends to the receiver.
6.2 ABORT REPORT
YES allows the panel to send an alarm abort report to the receiver any time an area is
disarmed after an alarm report has been sent and the Bell Cutoff Time has not expired. No
alarmed zones can still be armed. A Warning: Alarm Bell Silenced report is also sent if the
alarm bell is silenced by a user.
Abort reports are also sent when the system is disarmed during Transmit Delay and the Bell
Output Timer is active. See section 3.5.
6.3 RESTORAL REPORTS
This option allows you to control when and if a zone restoral report is sent to the central
station receiver. Press a top row SELECT key to display the following options:
NO - Disables the zone restoral report option. Zones continue to operate normally but do not
send restoral reports to the receiver.
YES - Enables the zone restoral report option. Zone restorals are sent whenever a zone
restores from a trouble or alarm condition.
DISARM - This option causes the panel to send non-24 hour zone restoral reports whenever
a zone that has restored from a trouble or alarm condition is disarmed. All 24 hour zones
send restoral reports as they restore.
6.4 BYPASS REPORTS
YES allows the panel to send all zone bypasses, resets, and force arm reports to the
receiver. The bypass report includes the zone number, zone name, and the user name and
number of the individual operating the system.
5 - REMOTE OPTIONS
6 - SYSTEM REPORTS
REMOTE PHONE NO
NBR RMT PICKUP
DISARM NO
SYSTEM REPORTS
ABORT NO
RESTORAL: YES
NO YES DISARM
BYPASS YES