Programming instructions

10
XR200 Programming Guide
2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282
3.29 SECOND TELEPHONE NUMBER
When PAGER? is NONE. The panel dials the second number when two successive tries
using the first number have failed. If the panel cannot reach the receiver after two attempts
using the second number, it returns to the first number and makes two additional attempts. A
total of ten dialing attempts are made using the first and second phone numbers.
Each number can be up to 15 characters in length including any P or D characters entered
for pause and dial tone detect.
3.30 PAGER IDENTIFICATION NUMBER
Enter a pager identification number if your pager uses one. If it does, the panel waits for nine
seconds after having dialed the First Phone Number before sending the Pager ID. After the
Pager ID has been transmitted, the panel waits another three seconds before sending the
actual pager message containing the panel reports. You can program additional three second
pauses by entering a letter P for each pause you want to add.
4.1 DEVICE SETUP
This section allows you to define the physical configuration of the XR200 panel. Enter the
number of partitions in the system and the types of devices installed at each address along
with their assigned partition. You can install and address up to eight supervised devices on
the keypad data bus, sixteen if the Model 485 Access Control Expansion card is used. Only
the first eight may be keypads or zone expanders. Any address may be a Model 733
Weigand Interface Module. No zones are available from addresses 9 - 16.
A description of each option follows:
4.2 MAXIMUM PARTITIONS
Maximum number of partitions you want in this system. You can choose from 1 to 4. To
change the number displayed, press any SELECT key, enter the number of partitions you
want to enable, and press COMMAND.
Changing the number of partitions resets user codes: Whenever you change the number of partitions on the
XR200, all programmed user codes are cleared. The only user code available after a partition change is the factory
default of 99.
Figure 5: Areas and user codes available with partitioning
MAX PARTITION: 1
DEVICE SETUP
3 - COMMUNICATION
PAGER ID NUMBER
–
SECOND PHONE NO
–
Partitions
Enabled
Areas Available
User Codes
Available
XR200
User Codes
Available
XR200-485
1 1 to 8 1 to 200 1 to 999
2 Partition 1 - 1 to 8
Partition 2 - 1 to 4
Partition 1 - up to 100
Partition 2 - up to 100
Partition 1 - up to 500
Partition 2 - up to 500
3 Partition 1 - 1 to 8
Partition 2 - 1 to 4
Partition 3 - 1 to 4
Partition 1 - up to 50
Partition 2 - up to 50
Partition 3 - up to 50
Partition 1 - up to 400
Partition 2 - up to 300
Partition 3 - up to 300
4 Partition 1 - 1 to 8
Partition 2 - 1 to 4
Partition 3 - 1 to 4
Partition 4 - 1 to 4
Partition 1 - up to 50
Partition 2 - up to 50
Partition 3 - up to 50
Partition 4 - up to 50
Partition 1 - up to 400
Partition 2 - up to 200
Partition 3 - up to 200
Partition 4 - up to 200
4 - DEVICE SETUP