Programming instructions

9
2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282
XR200 Programming Guide
3.19 SECOND TELEPHONE NUMBER
The panel dials the second number when two successive tries using the first number have
failed. If the panel cannot reach the receiver after two attempts using the second number, it
returns to the first number and makes two additional attempts. A total of ten dialing attempts
are made using the first and second phone numbers.
Each number can be up to 15 characters in length including any P or D characters entered
for pause and dial tone detect.
Should all ten attempts fail, the panel clears the communication buffer and makes one
communication attempt each hour to send a TRANSMIT FAILED (S87) report to the receiver.
The report information that was not sent to the receiver is available from the Display Events
feature of the User Menu and can be downloaded with DMP Remote Access™ software.
3.20 RECEIVER TWO PROGRAMMING
Allows you to set the options for the second receiver the XR200 panel attempts to contact
when sending reports. If you select YES for any of the second receiver options, you must
have at least one phone number programmed in Receiver 2 programming.
3.21 PAGER TYPE
This option allows the panel to send Alarm, Trouble, Opening, Closing, and Late to Close
reports to a customer's numeric or alphanumeric pager. The panel uses DTMF tones for
numeric pagers and Glenayre protocol for alphanumeric pagers to generate the account and
report information sent over the pager terminal equipment. Selecting NONE allows you to use
the Receiver 2 Programming to send panel reports to a second receiver.
NONE - The pager reporting option is not being used.
NUMERIC - Reports are sent to the customer's numeric only pager.
ALPHANUMERIC - Reports are sent to the customer's alphanumeric pager.
3.22 ALARM REPORTS
See section 3.12.
3.23 SUPERVISORY/TROUBLE REPORTS
See section 3.13
3.24 OPENING/CLOSING AND USER REPORTS
See section 3.14.
3.25 TEST REPORT
See section 3.15.
3.26 DOOR ACCESS REPORTS
See Section 3.16
3.27 BACKUP REPORTING
See section 3.17.
3.28 FIRST TELEPHONE NUMBER
Enter the phone number the panel will dial to send reports to the receiver or pager. Phone
numbers can be 15 characters in length. You can program a three second pause in the
dialing sequence by entering the letter P. You can program a dial tone detect by entering the
letter D. These characters are counted as part of the 15 allowable characters.
3 - COMMUNICATION
O/C USER YES
SPV/TRBL YES
ALARM YES
PAGER? NONE
NONE NUM ALPHA
BACKUP NO
TEST RPT YES
RECEIVER 2 PROG
–
SECOND PHONE NO.
–
FIRST PHONE NO.
DOOR ACS NO