Installation guide

Digital Monitoring Products XR200 Installation Guide
iv
REVISIONS
XR200 Installation Guide Digital Monitoring Products
1
INTRODUCTION
Product Specications
1.1 Power Supply
Transformer Input: 16.5 VAC 40 VA (Models 320 or 321)
Standby Battery: 12 VDC 7.7Ah (40 VA charges 2 batteries; 56 VA and 100 VA charges up to 4 batteries)
Auxiliary: 12 VDC output at 1 Amp
Bell Output: 12 VDC at 1.5 Amp
All circuits are inherent Power Limited except the red battery wire.
1.2 Communication
Built-in dialer communication to DMP Model SCS-1 and SCS-1R Receivers
Built-in multiplex communication to DMP Model SCS-1 Receivers
Built-in Contact ID communication to non-DMP receivers
Built-in Modem IIe communication to non-DMP receivers
Optional 893 or 893A Dual Phone Line Modules with phone line supervision
Optional Host communication through Ethernet data networks
Can operate as a local panel
1.3 Panel Zones
Eight 1k Ohm EOL burglary zones (zones 1 to 8)
Two 3.3k Ohm EOL Class B (Style A) powered zone with reset (zones 9 and 10)
1.4 Keypad Data Bus
You can connect up to eight of the following supervised keypads and expansion modules to the XR200 keypad
data bus: Alphanumeric keypads, four and single zone expansion modules, and single zone detectors.
1.5 LX-Bus™
You can connect the following devices to the LX-Bus™ provided by the DMP 462N, 462P, 462FM, 472, and 481
Interface Cards up to the maximum number of LX-Bus™ addresses. See Accessory Devices in section 3.4.
• Four and single zone expansion modules • Single zone detectors
• Relay output expansion modules • Graphic annunciator modules
1.6 Outputs
The XR200 provides two SPDT relay outputs which require the installation of two Model 305 relays, each
rated 1 Amp at 30 VDC resistive) power limited sources only. The XR200 also provides 8 auxiliary 12 VDC,
50mA resistive outputs. To use these outputs, you need one Model 430 Output Harness.
1.7 Enclosure Specications
The XR200 is shipped in an enclosure with End-of-Line resistors, battery leads, User’s Guide, and
Programming Sheets.
Model 349 Enclosure (XR200M) Dimensions: 12.5” W x 11.5” H x 3.5” D - 8 lbs with panel
Color: Black (61), Gray (63), or Red (81)
Construction: 20-gauge cold-rolled steel
Model 350A Enclosure (XR200A) Dimensions: 17.5” W x 13.5” H x 3.75” D (enclosure only)
Color: Black (61), Gray (63), or Red (81)
Construction: Door: 16-gauge cold-rolled steel.
Back and Sides: 18-gauge cold-rolled steel
Model 350 Enclosure (XR200L) Dimensions: 17.5” W x 13.5” H x 3.5” D - 10 lbs with panel
Color: Black (61), Gray (63), or Red (81)
Construction: 18-gauge cold-rolled steel