Installation guide

800-64 1- 42 82

www.dmp.com

Made i n th e USA

INTRUS IO N • FIRE • ACCESS • NE TW OR KS

2500 N or th Partners hi p Bouleva rd

Spring fi el d, Miss ou ri 65803-88 77

Operating Instructions for Model XR200 Panels

NORMAL STANDBY CONDITION

When the system is in the normal standby condition, the keypad shows either

the time of day or a blank display.

ALARM CONDITION

When the system is in an alarm condition, the keypad display shows the

violated zone name(s) followed by an alarm display.

ALARM SILENCE

To silence the alarm while the bell or siren is sounding, enter your code

number and press the COMMAND key. This silences the alarm but does not

cancel any alarm reports to the central station.

RESETTING DETECTORS

To reset a smoke or other detector, enter the User Menu by pressing the

COMMAND key until MENU? NO YES appears in the display. Press the top row

key under YES. The display shows ENTER CODE: -. Enter your code number

and press COMMAND. The keypad display now shows ALARM SILENCE?. Press

the COMMAND key until SENSOR RESET? appears in the display. Press any top

row key.

TROUBLE CONDITION

When a device is in a trouble condition, the keypad tones and displays the

zone or device name followed by TRBL. Press any top row key to silence.

SYSTEM TESTING

You should test the security system periodically to ensure proper operation.

You can do this through a function in the User Menu. After entering the User

Menu, press the COMMAND key until SYSTEM TEST? displays. Press any top

row key. The system bell, battery, and communication to the central station

receiver system is then tested.

ALARM SERVICE

If service is required for this system, please contact:

Company __________________________________

Address ___________________________________

Telephone _________________________________

The operating instructions above should be attached to the front, or framed

and located adjacent to, the panel or a Security Command keypad with an

alphanumeric display.