Programming instructions

Digital Monitoring Products XR200-485 Programming Guide
vi
REVISIONS
XR200-485 Programming Guide Digital Monitoring Products
1
INTRODUCTION
Revisions to This Document
This section explains the changes made to this document during this revision. It lists the date and
identies the change made, the related section number and section heading, and a summary of the change.
Date Section Number and Heading Quick Explanation of Changes
8/05 14.10 Early Morning Ambush Claried second user code operation.
15.20 Zone Retard Expanded and claried operation.
3/04 Entire Document Added iCOM-E where applicable corrected 4.2 Maximum Partitions
table, and removed references throughout to specic keypad
models. Added SCS-1R references to the appropriate places. General
review and grammar edits. Note: Section numbers have changed.
5/03 7.5 Zone Retard Delay Added description regarding Zone Retard Delay with an A1, A2, or
Arming using zone type with a light sensor.
8.5.3 Communication Fail Output Information added stating that the output can be turned off through
the User Menu.
8.5.10 Phone Trouble Output Section corrected to include output activation when short across
phone block pins 2 and 7 is lost.
14.17 Armed Output Number Sentence added to clarify that the Armed Output turns on at the
beginning of the exit delay.
15.13 Report to Transmit Supervisory zone type removed from UL note.
15.26 Connect Command Transmitter Press Reset button to initiate programming.
18.1 Diagnostics Function Note added to clarify wireless zone diagnostics.
18.2 Using the 984 Command Function Section rewritten to provide clarity.
18.3 Using the Walk Test Note added to clarify testing panic zones.
18.13 Inovonics Transmitter Information Section added with information about programming transmitters.
Note: Subsequent numbers changed.
18.14 Zone Type Descriptions Expanded A1 and A2 and Arming Zone explanations to include using a
light sensor. Blank Zone Type description added.
18.15 Zone Type Specications Expanded Retard Delay explanation to include using an Arming Zone.
10/02 3.2.3 Test Frequency New programming prompt added.
Note: Subsequent section numbers changed.
3.20 Receiver Two Programming Sentence added stating that the following prompts not shown if
COMM TYPE is HST and 2ND LINE is NONE.
3.28 First Telephone Number Information added clarifying pager information.
3.30 Pager Identication Number Information added clarifying pager information.
15.27 Transmitter Programmed Prompt added to documentation verifying that the wireless
transmitter was successfully programmed.
18.10 462N Interface Card Examples Table updated to reect proper conguration.
3/02 3.2.4 UL AA Check-in Time and Fail Time defaults changed to 1 (one).
1/02 3 Communication DNET programming type removed.
13 Host Log Reports Section added for Host Log Reports feature.
Note: All subsequent section numbers adjusted.
18.10 462N Examples Section added about using the 462N card.
12/01 3.2.1 Retry Time Section added for new programming operation.
3.2.2 Host Backup Section added for new programming operation.
3.2.3 Modem Setup Section expanded for new programming operation.
3.2.4 UL AA Section added for new programming operation.
17 Appendix Entire section rearranged for clarity.
17.3 Using the Walk Test Clarication added regarding bells.