Programming instructions

Digital Monitoring Products XR200-485 Programming Guide
46
APPENDIX
XR200-485 Programming Guide Digital Monitoring Products
47
APPENDIX
18.6 Pager Direct Specications
The XR200-485 communicates in full-duplex mode with a Glenayre alphanumeric pager terminal. The
terminal modem must accept the following parameters:
• 300 bps Bell 103 protocol
• Carrier detect response time = 300ms
• Delay between lost carrier and hang-up = 12.0 seconds
The following alphanumeric pager specications must also be met in order for the pager to receive Pager
Direct reports:
Glenayre Electronics GL3000 protocol:
• 300 Baud
• 7 Bits Data
• 1 Stop Bit
• Even Parity
18.7 Events Manager
The Events Manager allows you to delay sending certain reports to the central station receiver. Reports can
be kept in the panel memory until overwritten by new activity or held until the memory buffer reaches 133
events. When the buffer is lled, the panel automatically sends the stored reports to the central station
receiver. Below is a list of panel reports that can be delayed using the Events Manager option.
Report Type Immediately Delayed
Alarm Y
Trouble Y
Restore Y
Opening Y
Closing Y
Bypass Y
Reset Y
Supervisory Y
Add Codes Y
Delete Codes Y
Change Codes Y
Permanent Schedule Change Y
Temporary Schedule Change Y
Door Access Y
Door Access Denied Y
Late to Close Y
Force Armed Zone Y
18.8 Modem Setup Information
When a report is to be sent, the panel rst sends “+++ATH
c
r
(carriage return)”, waits one second then sends
the dial string characters entered in MODEM SETUP. This is followed with a space and a “
c
r
.” The modem
must respond to the panel with “CONNECT
c
r
”.
If “CONNECT
c
r
” is properly received from the modem, the standard HST report/response sequences occur.
After a report is sent and acknowledged, or a report is sent and not acknowledged for a period of one
minute, the panel sends “+++ATH
c
r
” to the modem.
If no response is received from the modem after 60 seconds, the cycle repeats. Any string other than
“CONNECT
c
r
” that is returned by the modem and ends with a “
c
r
” is ignored. After three cycles and no
connection is made, a NETWORK TROUBLE message is sent to the central station if UL AA is selected as
YES.
If the Host channel fails to receive a proper acknowledgment within 60 seconds, the panel sends a
WARNING: NETWORK TROUBLE (S72) report on the 2ND LINE. The next time a report is sent by the panel
over the Host channel, the panel sends a NETWORK RESTORED (S73) report over the 2ND LINE.