Programming instructions

Digital Monitoring Products XR200-485 Programming Guide
42
APPENDIX
XR200-485 Programming Guide Digital Monitoring Products
43
APPENDIX
Overlap
An overlap occurs when a device address is the same as any of the last three zones on another 714 or 715.
Note: The overlap feature cannot determine when two devices have the same address.
Example
714 Address 00 711 Address 02
Zones 100 101 102 103 Zone 102
Overlap
Missing
Missing occurs when a zone between 100 and 299 has been programmed in ZONE INFORMATION and
no device with that zone address is installed on the LX-Bus. To correct the problem, check your zone
expansion module programming and addressing.
Extra
A device is installed on the LX-Bus™ but one or more of its zones are not programmed into the system.
Exiting the Diagnostics program
To exit the Diagnostics function, press the Back Arrow key until STOP displays then press any Select key.
The keypad returns to the Status List display.
18.2 Using the 984 Command Function
This feature allows you to connect to a service receiver and is used primarily to bring a new account on-
line and upload panel programming completed in Remote Link™. There are three options to allow manual
phone line seizure: Number, Remote, and Pickup.
NBR
After completing panel programming in Remote Link, set a trap to seize the panel when it calls. Traps are
set by selecting Panel > Trap. Refer to the Remote Link User’s Guide, LT-0565, or Remote Link Help File.
Then, from the panel, enter 984 and the COMMAND key, while the panel displays in the Status List. The
keypad display changes to NBR RMT PICKUP. Press the Select key under NBR. Enter the phone number
for the service receiver connected to the Remote Link computer. Press each number key slowly and
deliberately. The panel dials each number as it is pressed. If you make a mistake, press the Back Arrow
key. The panel stops dialing and returns to the Status List.
You can enter up to 32 characters for the phone number. Once you enter 16 characters the LCD display is
full: Press the COMMAND key to enter the nal 16 characters. To enter a # (pound sign) press the fourth
(far right) Select key, and to enter an * (asterisk) press the third Select key. Program a pause by entering
the letter P. Program a dial tone detect by entering the letter D. These characters are counted as part of
the allowable 32 characters. Press COMMAND after you enter the phone number.
The panel calls the receiver connected to Remote Link to download the new programming. Remote Link
then traps the panel.
Note: The panel makes ten attempts to reach the receiver. If while attempting to contact the receiver, the
panel needs to send an alarm report, the panel stops dialing and uses the phone line to send its report.
RMT
Select RMT if you want the panel to immediately seize the phone line and dial the remote phone number
programmed in the panel programming Remote Options section. The Remote Options phone number is to
the modem being used by the DMP Remote Link™ software program.
After completing panel programming in Remote Link, set a trap to seize the panel when it calls. Traps are
set by selecting Panel > Trap. Refer to the Remote Link User’s Guide, LT-0565, or Remote Link Help File for
complete information about setting traps.