Programming instructions

Digital Monitoring Products XR200-485 Programming Guide
32
AREA INFORMATION
XR200-485 Programming Guide Digital Monitoring Products
33
AREA INFORMATION
14.13
ACCOUNT NO: 12345
Account Number
Enter the account number to be sent to the receiver for this area. Choose
an account number compatible with the Communication Type selected in
Communications. The default Account Number is the one previously entered. If
the Communication Type selected multiplex, you must choose an account number
between 128 and 999.
Proper multiplex account number assignments to DMP SCS-1 Receivers:
Receiver Line Main Account # Area Account #
1 10000 to 10127 10128 to 10999
2 20000 to 20127 20128 to 20999
3 30000 to 30127 30128 to 30999
4 40000 to 40127 40128 to 40999
5 50000 to 50127 50128 to 50999
14.14
AUTO ARM NO YES
Automatic Arming
Select YES to allow this area to arm automatically according to permanent,
temporary, or extended schedules. If no schedules are programmed, the area auto
arms every hour.
If closing check is selected as YES, the automatic arming function does not take
place until the expiration of a ten minute Closing Check delay. See Closing Check.
If the area is disarmed outside of any permanent or temporary schedule, the closing
check sequence occurs one hour after the area is disarmed.
At arming, bad zones are handled according to the option selected in section Bad
Zones. If a closing report is sent, the user number is indicated as SCH on the SCS-1/
SCS-1R Receiver. NO disables automatic arming for this area.
14.15
BAD ZONES: BYP
Bad Zones
At the time of automatic arming, some zones in the area may not be in a normal
condition. This option allows you to program the panel response to these bad zones.
This option is not displayed if AUTO ARM is NO.
BYP FORC REF
BYP - All bad zones are bypassed. A bypass report is sent to the receiver if Bypass
Reports is YES. The report indicates SCH as the user number.
FORC - All bad zones are force armed. Zones force armed in a bad condition are
capable of restoring and reporting an alarm if tripped. A forced zone report is
transmitted if Bypass Reports is YES. The report indicates SCH as the user number.
REF - The automatic arming is refused and no arming takes place. A No Closing
report is sent to the receiver regardless of the Closing Check selection.
14.16
AUTO DIS NO YES
Automatic Disarming
NO disables automatic disarming by schedule for this area. When YES is selected,
the area automatically disarms according to permanent or temporary schedules. If
an opening report is sent to the receiver, the user number is indicated as SCH.
14.17
ARMED OUTPUT: 0
Armed Output Number
Enter the output to turn on when this area is armed. If an exit delay is used for this
partition, the Armed Output turns on at the start of the exit delay. The output turns
off when this area is disarmed. The output cannot be turned on from the Outputs
On/Off option of the User Menu.
14.18
LATE OUTPUT: 0
Late Output Number
Enter the output to turn on when this area is not armed by its scheduled time and
Area Late or Closing Time displays at a keypad and the keypad buzzer is on. The
output turns off when the keypad buzzer is silenced by pressing any key. Default
is 0.