Programming instructions
Digital Monitoring Products XR200-485 Programming Guide
24
OUTPUT GROUPS
XR200-485 Programming Guide Digital Monitoring Products
25
MENU DISPLAY
Output Groups
9.1
OUTPUT GROUPS
Output Groups
This function allows you to assign outputs to groups. Output groups can be assigned
to other areas of programming such as Output Options or Zone Information Alarm
Action, the same way single outputs are assigned. This allows the entire group of
outputs to turn on and off as required by the programming option.
9.2
GROUP NO: -
Group Number
Enter a group number from 1 to 20. Up to 20 different groups may be assigned.
9.3
GROUP NAME X X
Group Name
The group name displays. To change the default name, press any top row Select key
then enter up to 16 characters for the group name. Press COMMAND to enter the
outputs to be assigned to the group.
9.4
OUTPUT NO 1: -
OUTPUT NO 2: -
OUTPUT NO 4: -
OUTPUT NO 5: -
OUTPUT NO 3: -
OUTPUT NO 7: -
OUTPUT NO 8: -
OUTPUT NO 6: -
Output Number
Enter the Output number. Entry range is 1 to 10, 100 to 299 (outputs), D1 to D16
(doors), and G1 to G20 (groups). The maximum number of outputs that can be
assigned to a specic group is eight.
An output group may be assigned as one of the output numbers in another output
group.
Example: Output Group 1 consists of only four assigned outputs. Output Group
1 could be assigned as one output in Output Group 2. Output Group 2 could still
have 7 other outputs assigned to that group. When Output Group 2 is turned on, 11
outputs could turn on. This allows Output Groups to be assigned within other Output
Groups providing many combinations.
Output groups 1 to 10 can be assigned by a user prole for applications such as
elevator control. See the XR200-485/485B User’s Guide (LT-0364) Output Group
section for additional information.
Output groups 11 to 20 cannot be assigned to a prole and are available for
installation applications such as special lighting, etc. To assign these groups to a
prole, use Remote Link™ or System Link™ software from DMP.