Programming instructions
Digital Monitoring Products XR200-485 Programming Guide
2
INTRODUCTION
XR200-485 Programming Guide Digital Monitoring Products
3
INTRODUCTION
1.5 Reset Timeout
The panel has a feature that requires you to enter the Programmer within 30 minutes of resetting the
panel. After 30 minutes, if you attempt to program by entering the 6653 (PROG) code, the keypad
displays: RESET PANEL. You must reset the panel, enter the program code, then begin programming
within the next 30 minutes.
If you are already in the Programmer and do not press any keys on the programming keypad for 30 minutes,
the panel terminates programming. All data entered up to that time is saved in the panel memory.
1.6 Special Keys
COMMAND Key
The COMMAND key allows you
to go forward through the
programming menu and through
each step of a programming
section. As you go through the
programming, the keypad display
shows any current programming
already stored in the panel
memory. If the information is
not to be changed, press the
COMMAND key to advance to the
next step.
The COMMAND key is also used
to enter information into the
panel memory such as phone numbers or zone names. Press the COMMAND key after you have entered the
information and it displays correctly on the keypad.
Back Arrow Key
Use the Back Arrow key to back up one step while programming. The Back Arrow key is also used when
an error is made while entering information. Press the Back Arrow key once to erase the last character
entered.
Select Keys
The top row of keys are called the Select keys. Each time you need to use a Select key, the keypad
displays the function or options above the key. Displaying choices above individual Select keys allows them
to be used for many different applications. For example, you can enter AM or PM when programming the
automatic test time or answer YES or NO for a system option.
During programming, the Select keys also allow you to change information currently in the panel memory
by pressing the appropriate Select key under the display then entering the new information through the
keypad.
When there are more than four response options available, pressing the COMMAND key brings up the next
one to four options on the keypad display. Pressing the Back Arrow key allows you to review the previous
four choices.
The Select keys are also used for selecting a section from the programming menu by pressing any one of
the Select keys when the name of the programming section you want is displayed.
1.7 Entering Alpha Characters
Some options during programming require you to enter alpha characters. To enter an alpha character,
press the key that has that letter written below it. The keypad displays the number digit of the key. Next,
press the Select key that corresponds to the location of the letter under the key. Pressing a different
Select key changes the letter. When another digit key is pressed, the last letter displayed is retained and
the process starts over.
Figure 3: Entering Alpha Characters
Figure 2: Keypad Function Keys
�