User`s guide

XR500 User’s Guide 51Appendix C
Frequently asked questions
This section attempts to answer questions you might have regarding Security Command system operation.
Q. If I bypass an exit delay door when I arm the system, will I get an alarm if I come through it later?
A. You will not get an alarm from the door because it is bypassed, but if you happen to walk through a motion detector space or other
armed door inside the premises an alarm activates.
Q. When I arm or disarm my Area system, ALL? NO YES displays. Does this mean all areas in the system?
A. Choosing YES arms or disarms all areas that are authorized for your user code.
Q. How do I create a schedule that starts at 8:00 AM on Monday and ends at 5:00 PM on Friday.
A. In the days of the week display, select MON (Monday). For the OPENING TIME?, enter 0 + 8 + 0 + 0 AM. For the CLOSING TIME?, at
the MON — : AM PM display press the Select key under MON; this scrolls through the days of the week. Stop at the day you want the
schedule to end. Next, enter 0 + 5 + 0 + 0 PM into the FRI — : AM PM closing time display. Press COMMAND. Press the Back Arrow key
to exit the User Menu.
This sets the opening time to 8:00 AM Monday and the closing time to 5:00 PM Friday. You can substitute any other day or time in this
example.
Q. What do I do if I want to be in the building past the scheduled closing (arming) time?
A. If your system is programmed for closing check, the keypad emits a steady tone prior to the system arming. During this tone, press
any Select key to display ENTER CODE: . Enter your user code and press COMMAND.
The keypad now displays the enter time display — : AM PM. Enter in the new time you want the system to arm and press COMMAND.
The time you enter may extend past midnight by pressing the AM key after entering the appropriate time.