User`s guide

XR500 User’s Guide 23User Menu
Deleting User Profiles
1. Access the User Menu.
2. Press COMMAND until USER PROFILES? displays.
3. Press any Select key. The keypad displays ADD DEL CHG.
4. Press the second Select key, under DEL, to delete a user
proÞ le.
5. At the PROFILE NO: - prompt, enter a proÞ le number and
press COMMAND. The display changes to DELTD.
Note: User codes assigned to deleted proÞ les will not function.
Changing User Profiles
1. Access the User Menu.
2. Press COMMAND until USER PROFILES? displays.
3. Press any Select key. The keypad displays ADD DEL CHG.
4. Press the far right Select key, under CHG.
4. At the PROFILE NO: - prompt, enter a proÞ le number and
press COMMAND. The display changes to PROFILE NAME.
5. Press any Select key to display -. Enter a proÞ le name of up
to 16 characters. The default ProÞ le Name uses the ProÞ le
Number. Enter the name and press COMMAND.
6. At the Arm/Dis AREAS: prompt, enter the area numbers (1-
32) for arming and disarming assigned to this proÞ le.
7. The keypad displays ACCESS Areas: . Enter the area numbers
(1-32) assignment to allow door access for this proÞ le.
Press the COMMAND key.
8. The keypad displays OUTPUT GROUP: -. Enter the number
(1 through 20) for the Output Group assigned to this proÞ le.
Press the COMMAND key.
9. The keypad displays each of the menus as shown in the
ProÞ le Table. You then enable or disable the menu function
for this proÞ le number. Select YES or NO and press the
COMMAND key to advance to the next menu selection.
10. When you complete Selecting all User ProÞ le menu
assignments, the keypad displays the PROFILE CHNGD
message for 4 seconds, indicating the proÞ le is changed.
TEMP CODE
When you select YES for this menu option, and this proÞ le
is assigned to a user code (see next section), the keypad
displays TEMP EXPIRE DATE:. Enter the ending date for the
proÞ le to expire. Default is seven days from today. The
system deletes Temp users at 12:00 AM on the last date.
ANTI PASS NO
Anti-passback requires that you properly exit (egress) an
area previously accessed. If you fail to exit through the
proper location you cannot access it until you properly exit.
Default is No. See page 6 for more information.
ALOW: 1 2 3 4 ANY
This menu option deÞ nes the time schedules that the User
Code operates for door access and disarming. Selecting
1, 2, 3, and/or 4 indicates operation during the S1-S4
shift schedules. Selecting ANY (fourth Select key) from
the menu indicates the code operates any time, regardless
of schedules. You may select all shift schedules for one
user. Menu access is not affected by this option. An
UNAUTHORIZED ENTRY message is sent to the central station
if disarming occurs outside the open/close schedule.
Browser Feature
Refer to Appendix B in this guide for a diagram showing you how to
use the Output Group browser and the ProÞ le browsers.