User`s guide
14 XR500/XR100 User’s Guide Arming and Disarming
XR500/XR100 User’s Guide 15Arming and Disarming
In some cases, you might see the keypad display FRONT DOOR
— FAULT. The keypad then displays priority zone which is a
zone that cannot be bypassed. The problem on the zone must be
corrected before the system can be armed.
When choosing to bypass a protection device or zone, there may
be a pre-programmed maximum number of zones (up to 8) that
can be bypassed in an area when that area is being armed. This
limit is programmed at installation.
Arming Messages:
For all systems the keypad briey displays ALL SYSTEM ON when
all areas in the system are armed.
For Area systems the keypad briey displays SYSTEM ON if only
selected areas are armed.
For All/Perimeter systems the keypad briey displays PERIMETER
ON if only selected areas are arming.
For Home/Sleep/Away systems the keypad displays HOME SYSTEM
ON or SLEEP SYSTEM ON if only selected areas are arming.
Exit Delay: The keypad then displays the exit delay time as it
counts down. Your system may be pre-programmed at installation
to beep the exit delay tone at eight-second intervals until the last
10 seconds when the keypad beeps at three-second intervals. After
exiting the building, if you re-enter during the countdown the exit
countdown restarts, allowing additional time to then disarm or again
exit the building during the countdown. This restart can occur only
one time. When the exit delay time expires, all disarmed zones are
armed.
Note: If your system uses a keyswitch to arm an area, the exit
delay time does NOT show on the keypad display.
When you arm both the Perimeter and Interior to leave the
building but then you do not exit by the time the exit delay ends,
the system automatically arms but the interior area(s) will remain
disarmed because you have not exited.
Should you exit the building and the door does not close properly,
your system may be programmed so that when the exit delay
countdown ends, then the entry delay starts and the bell will sound
to alert you to the situation. Enter your user code to stop the bell
and disarm the system. Rearm the system, exit the building, and
make sure the door is securely closed.
ONE MOMENT . . . Message: If your system is monitored, it
may be programmed to wait for the arming report transmission
to the central station before displaying the armed message. This
veries your phone lines are working properly. While the system is
waiting for the transmission, the display reads ONE MOMENT... If
the report is received, the keypad displays the armed message. If
the report is not received, the keypad displays LOCAL ALARM ONLY
before displaying the armed message.
Note: Your system may be pre-programmed at installation to:
— send arming or zone bypassing reports to a central station
— arm and/or disarm specic areas at specic keypads.
Key Fob Arming
Press and hold the key fob button programmed for Arming
or the Toggle arm/disarm button. The Red LED two-second
acknowledgement light indicates All System On. The Green/Red
two-second acknowledgement light indicates System On with some
areas armed.