User guide

Preparations in the Device Manager server

For the Device Manager server property, specify the name of the host from

which performance information is acquired. To specify the host name for the

server.cim.agent property in the server.properties file, use one of the

following methods:

• When specifying the host name during the installation of the Device

Manager server:

Enter the host name as indicated in the message displayed during the

installation of the Device manager server. That name will be set for the

server.cim.agent property in the server.properties file.

• When directly editing the server.properties file:

For the

server.cim.agent property in the server.properties file of the

Device Manager server, specify the name of the host where the Device

Manager agent is installed. After specifying the host name, restart the

Device Manager server. For details on the

server.cim.agent property, see

server.cim.agent

Note: Verify that the host name specified for the

server.cim.agent

property matches the host name registered in Device Manager for the

host that acquires performance information. If these host names are

different, you cannot acquire performance information.

Settings in the perf_cmddev.properties file

Edit the perf_cmddev.properties file to define the command device of the

target storage subsystem. The

perf_cmddev.properties file is stored in the

following location:

• Windows:

installation-folder-for-the-Device-Manager-

agent\mod\hdvm\config\perf_cmddev.properties

• Solaris or Linux:

/opt/HDVM/HBaseAgent/mod/hdvm/config/perf_cmddev.properties

Use the following format to define the command device in the

perf_cmddev.properties file. Define one command device per line.

Raid-ID.serial-number.LDEV-number: deviceFileName

The following table describes values to be specified in the

perf_cmddev.properties file.

1-22 Overview and Setup of CIM/WBEM

Hitachi Device Manager SMI-S Provider Installation and User Guide