User guide

Setting up the Properties File Used by the CIM/WBEM
Feature
When executing CIM, you must set up the properties files for the Device
Manager server, then restart Device Manager. The following table lists the
Device Manager server properties.
Table 1-4 Required Settings for Device Manager Server When
Executing CIM
Settings Required File Name Property
server.cim.support
server.cim.support.protocol
server.properties
server.cim.http.port
server.cim.https.port
server.cim.agent
Enable CIM, specify ports
used in CIM, and
configure settings
required to use the
performance information
acquisition feature and
the job setting feature.
server.cim.support.job
Classpath
BaseDir
wbemservices.properties
Propdir
Set up the operating
environment for the
WBEM Service.
Logdir
cimom.properties org.wbemservices.wbem.cimom.pswdprov
Set the authentication
class for Device
Manager.
The server.properties File
When executing CIM, set up the following properties in addition to the regular
settings.
server.cim.support
This property specifies whether to use the CIM interface. Set the
server.cim.support property to true. The default is false, which specifies that
the CIM interface is not used.
# whether the server supports CIM interface or not
server.cim.support={true | false}
server.cim.support.protocol
Specify whether to open or close the port used by the CIM interface.
Default: 3 (opens both the port for SSL communication and port for non-SSL
communication.)
1-10 Overview and Setup of CIM/WBEM
Hitachi Device Manager SMI-S Provider Installation and User Guide