Specifications

1070 072 131-102 (96.08) GB
BUEP19E Protocol7-12
7.5.4 Error Catalogue
Fault information
PLC
response
Error class Error code Explanation
00 00 00 Fault-free job
01 34 05 Protocol cannot be implemented due to an internal protocol
fault (RST)
- No connection
- Faulty connection
- Interface hardware not ready
- The incoming message cannot be analysed
01 30 02 Memory access fault (RST)
Faults occurred when RST memory area was accessed. Data
incorrectly read or incompletely written
01 30 03 Wrong memory type (RST). The type of access for the
addressed RST memory is not permitted (e.g. writing to
EPROM)
01 30 05 Internal communications fault (RST)
Fault during the processing of a command
01 30 20 Unknown command code (RST)
01 30 21 Unknown protocol identifier (RST)
01 30 25 Wrong parameter identifier (RST)
01 30 26 Block-length fault (RST)
01 30 28 Unknown message type (RST)
01 30 29 Unknown command type (RST)
01 30 3A Wrong address alignment (RST)
01 30 3B Invalid address area (RST)
01 30 3C Invalid parameter (RST)
01 30 3D Invalid operand type (RST)
01 30 63 Buffer overflow
The data length is larger than the available memory location of
800H bytes (memory area of BÜP19E).
02 32 01 Module not available (PST)
The indicated block address addresses a system area which
does not contain a module.
02 32 10 Module not addressable (PST)
The indicated block address has no module number
02 32 20 STOP fault (PST)
02 32 21 RUN fault (PST)
02 32 22 Operating mode cannot be changed (PST)
02 32 23 Field access prohibited (PST), unauthorised access mode
02 32 24 Field protection active )
02 32 25 Timer disabled (PST)
02 32 26 Module number too high (PST)
02 32 27 No data module (PST)
02 32 28 Data module too small (PST)
02 32 29 Monitor disabled (PST)
02 32 2A Reference list disabled (PST)
02 32 2B System-clock fault (PST)
02 32 2C Reference-list entry cannot be changed (PST)
Fig. 7-15 BÜP19E — Fault messages, Part 1