Specifications

13 – Configuring Reports
260 R400
Status Shows the current status of the report, which can be:
• Ready - the report is not running.
• Working - the report is running.
• Finishing - a complete batch report is being
generated.
• Error - the report has stopped because of an error.
Start time The time/date when the report started.
End time The time/date when the report competed.
If Status is set to
Working, End time is replaced by
Duration.
Duration Only visible if the report is running. The length of time
in days, hours, minutes and seconds that the current
report has been running.
Current sequence num,
or
Last sequence num
Current sequence number is only displayed if the
report is running. Indicates the sequence number that is
currently being used.
Last sequence number is only displayed if the report
is not running. Indicates the sequence number that was
used the last time the report was run.
Request Calls up the report.
If the report is running, the data available from the time
the report started to the time of the request is displayed.
If the report is not running, the last report that was run
is displayed.
If you want to start the report, see “Starting and
Stopping a Batch Report” on page 263.
Reset sequence num Sets the value of Last/Current sequence num to
0.
Batch Report Filename The report’s filename.
If Product Re-run is set to
Yes, the incremental re-run
number is used. If the report is being run, the next
partial report number is used.
Property/Button Description
plscpcg.book Page 260 Monday, May 28, 2001 10:11 AM