Specifications

10 – Configuring Security and Access
214 R400
Configuring Station-Based Security
If you have opted for the Station-Based security method, it is recommended that
you change the default passwords (one each for ENGR, SUPV, and MNGR) that
were installed as part of the PlantScape installation process.
Under Station-based security, only levels SUPV, ENGR, and MNGR require
passwords because:
• LVL1 and LVL2 are not available.
• Users can access OPER level without entering a password.
Setting and Changing Passwords for Security Levels
Default passwords are set for ENGR, SUPV, and MNGR at each Station as part of
the installation process. These default passwords are the same as the acronym
used for that security level; for example, the default password for MNGR security
level is mngr.
To change a Station password for ENGR, SUPV, or MNGR:
1 Log on to the PlantScape server with a Windows account that belongs to the
Honeywell Administrators group.
2 Open a Command Prompt window.
3 At the command line, enter the following command:
paswrd
4 Specify the Station number as follows:
C
nn
where nn is the number of the Station for which you want to change the
password(s)
5 Enter the number for the security level for which you want to change the
password:
1 for SUPV
2 for ENGR
3 for MNGR
6 Type the new password. The password can be either 5 or 6 alphanumeric
characters.
Note Passwords are case-sensitive.
7 Enter Q (for quit).
plscpcg.book Page 214 Monday, May 28, 2001 10:11 AM