Specifications

Configuring Alarm Paging
PlantScape Server and Client Configuration Guide 205
Note The following table of modems is correct as at the publication of
this document.
Configuring Pager Details
Each pager that is to receive alarm messages from Alarm Paging must be
configured on the Pagers tab of the Alarm Paging display:
To configure a pager:
1 In the Name field, type the name of the person (or group) to whom the
pager is assigned.
2 In the Phone Number/Pager ID field, type the pager ID number.
This ID is specified by the Pager Service Provider as a unique identifier for
the pager you are recording.
Phone Ringing The response which the modem issues if it detects that
the line is ringing on the other end. The default is
RINGING.
Change to RING for modems in List A and List B*.
Connection Detected The response issued by the modem if it detects that the
connection with the provider’s modem at the other end is
successful. The default is
CONNECT.
No Carrier Detected The response issued by the modem if it detects that there
is no modem on the other end of the line or if the other
party has hung up. The default is
NO CARRIER.
No Dial Tone Detected The response issued by the modem if no dial tone is
found on the line used by the modem. The default is
NO
DIALTONE
.
* Refer to Table 9.3, “List of Supported Modems,” on page 205.
Property Description
Table 9.2 Modem Information Fields (Continued)
List A List B
US Robotics Sportster 28,800, 33,6
3Com U.S. Robotics 56KFax Modem (Model 5676)
X-Link XL-V336E
ELSA MicroLink 28.8TQV, 2460TL
Table 9.3 List of Supported Modems
plscpcg.book Page 205 Monday, May 28, 2001 10:11 AM