Specifications

9 – Configuring Alarm Paging
204 R400
Initialization Command The command string needed to set the modem to the
settings as required by the provider.
The default string is
AT&D0E0X0%C0M0\N0B0 where:
D0 = Ignore DTR
E0 = Local command state echo off
X0 = basic response codes (must include ringing)
%C0 = Compression disabled
M0 = speaker is always off (optional)
\N0 = constant speed mode
B0 = auto-connect
Change to AT&D0E0X1&K0M0&B0 for modems in List
A and List B*.
No Flow Control The command needed to set the modem to No Flow
Control. The default is AT&K0.
Change to AT&HO for modems in List A and List B*.
Hardware Flow Control The command needed to set the Modem to hardware
Flow Control. The default is
AT&K3.
Change to AT&H1 for modems in List A and List B*.
XON\XOFF Flow Control The command needed to set the modem to Software flow
control. The default is
AT&K4.
Change to AT&H2 for modems in List A and List B*.
Dial Command The command preceding the phone number which tells
the modem to go on hook and dial the provider number.
The default is
ATDW.
Escape Sequence The command needed by the modem to return from data
send mode to local command state. The default is
+++.
Hang Up Command The command needed by the modem to replace the hook
and hang up the line. The default is ATH.
Change to ATH0 for modems in List A and List B*.
Command Successful The response which the modem issues if the command
sent to it was understood by the modem and successful.
The default is
OK.
Property Description
Table 9.2 Modem Information Fields (Continued)
plscpcg.book Page 204 Monday, May 28, 2001 10:11 AM