Specifications

Configuring Alarm Paging
PlantScape Server and Client Configuration Guide 203
6 Click Set Password to set an Alarm Paging password (if required).
The password is usually supplied by the service provider. For example, for
PET protocol the password usually has the format “PG1xxxxxx”, where
xxxxxx is the password supplied by the service provider. (If the provider
does not supply a password, you might still need to set the Alarm Paging
password to PG1. Check with your provider for details.)
7 Select the appropriate settings from the drop-down list for each of the
following:
• Protocol
•Baud Rate
• Data Bits
•Parity
•Stop Bits
•Flow control
Configuring Modem Information
Alarm Paging requires information on how to communicate with your modem. To
enter this information, open the Alarm Paging display at the Modem Information
tab. The following table discusses the modem information fields on this display.
Changes you enter on the Alarm Paging - Modems display take effect
immediately. If necessary, you can restore the default modem information by
pressing the Restore button. Pressing Restore overwrites any information that is
currently entered in the Modem Information tab.
The default settings in the following table are correct for the Netcom Roadster.
Property Description
Modem Reset Command The command needed to set the modem to the default
factory settings. The default is AT&F.
Change to AT&F0 for modems in List A*.
Table 9.2 Modem Information Fields
plscpcg.book Page 203 Monday, May 28, 2001 10:11 AM