Specifications

8 – Configuring Points
120 R400
Main Properties
This section describes the main properties of PlantScape points. Some properties
are common to all point types, and some are specific.
The main properties that are common to all point types are:
The main properties common to status, analog, and accumulator points are:
The main properties specific to Status Points are:
The main properties specific to Analog Points are:
Property See…
Point ID: “Point ID” on page 121.
Description: “Description” on page 122.
Area Code: “Area Code” on page 122.
Property See…
PV Source Address: “Source and Destination Addresses” on page 144.
PV Scan Period: “Source and Destination Addresses” on page 144.
Property See…
Number of States: “Number of States” on page 124.
State Descriptors: “State Descriptors” on page 124.
Scanning Enabled: “Building Points Off-Scan” on page 181.
Property See…
Engineering Units: “Engineering Units” on page 127.
Range High Value and
Range Low Value:
“Range High Value and Range Low Value” on page 127.
Drift Deadband: “Drift Deadband” on page 127.
Clamp PV: See “Clamp Point” on page 128.
plscpcg.book Page 120 Monday, May 28, 2001 10:11 AM