User manual

82
4.6 PTZ Configuration
The PTZ screen (Refer to Fig. PTZ Configuration) contains the following parameters for Pan Tilt
Zoom (PTZ) control configuration:
Parameters Default Table
PTZ Device RS485 Device
Channel 1
Protocol PELCOD NONE
Address 1 1
Baudrate 9600 9600
Data Bits 8 8
Data Bits 1 1
Stop Bits None None
Parity 0
Monitors 0
PTZ Device
<Channel>: select the corresponding channel (camera) for Pan Tilt Zoom (PTZ) control configuration
Note: A PTZ camera needs to be connected to the corresponding channel
<Protocol>: select the PTZ control protocol from the available list
<Address>: enter the address
<Baudrate>: select the baud rate from 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200
<Data Bits>: select the data bits from 5, 6, 7, or 8
<Stop Bits>: select the stop bits from 1 or 2
<Parity>: select the parity check from None, Odd, Even, Mark, or Space
<Monitors>:
RS485 Device
<Protocol>: select the PTZ control protocol from the available list
<Address>: enter the address
<Baudrate>: select the baud rate from 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200
<Data Bits>: select the data bits from 5, 6, 7, or 8
<Stop Bits>: select the stop bits from 1 or 2
<Parity>: select the parity check from None, Odd, Even, Mark, or Space