Instruction manual

- 48 -

The general operations are as below:

 ▲▼◄►

Press these buttons to select the items.

 MODE => Format/Clear

Press this button to format/clear the HDDs as described in Section 6.6.1

 ESC

Press this button to escape from this screen, and return to Setup Menu display. If

the Save dialog is shown, press ENTER to exit and save, ESC to exit without

saving.

Following is a brief description for each item and its specific operations:

 Size (GB) – the total HDD storage in GB (Giga-Byte) for Alarm Record and

Normal Record respectively. This item is just for information. Please refer to

Section 6.6.1

for more detailed information and setup of each individual HDD.

 Auto Overwrite – automatic overwrite of the recorded video/audio from HDD#1

when the Alarm/Normal Record disk drive capacity reaches the end of the last

HDD. If Auto Overwrite is disabled and the Alarm/Normal Record disk drive

capacity reaches the end, the system will not overwrite the recorded video/audio,

and hence not record Alarm/Normal video/audio, until the user presses the Alarm

Reset button. Press ENTER or +/- to check/uncheck this item. The default

setting is “” - checked.

 HDD Full Action – actions when Alarm/Normal Record disk drive capacity

reaches the end of the last HDD. Press ENTER or +/- to check/uncheck this

item. The default setting is “” - checked.

 Duration – response duration to define at most how long (in seconds) the Alarm

Out relay and the Buzzer will keep being triggered after the corresponding

partition, Alarm Record or Normal Record, is full. Press +/- buttons to adjust the

value (3 seconds - 60 minutes, discrete, ‘-‘ for ‘Forever’).

 Alarm Out – to define which Alarm Output will be triggered when the

corresponding partition, Alarm Record or Normal Record, is full. Press +/-

buttons to select none (N/A) or one of the Alarm Outputs (1-4).

 Buzzer – to activate the internal Buzzer or not when the corresponding partition,

Alarm Record or Normal Record, is full. Press ENTER or +/- to check/uncheck

this item. The default setting is “” - checked.

 Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this

item. The default setting is “” - checked.

SCW-7709 & SCW-7716 Users Manual