User guide

PN# 500-10440
Page 2 Rev. F, 02/12
3.1 HARDWARE
10X 20X 1X
Phillips Flat Head
#10 X 3/4” Type “A”
Socket Flat Head
10-32 X 3/8”
Hex Wrench
1/8”
8X 4X 1X
Shim Plate Flush Mount Bracket
Thread Locking Compound
Pack
1X
Floor Install Replacement
Spring Pack (2 Springs)
4 RECOMMENDED TOOLS
Router or Saber Saw 1/8” Hex Key (Allen Wrench) - included
Hammer Measuring Instrument (Ruler/Tape Measure)
Chisel Masking Tape
Center Punch Fish Tape or Lead Wire
Power Drill Wire Strippers/Cutter
9/64”, 13/64” & 5/16” Drill Bits Crimp Wire Connectors
3/8” Diameter X 82° Countersink Bit Crimp Tool
Phillips and Standard Screwdrivers Multimeter
5 INSTALLATION INSTRUCTIONS
5.1 Pre-Installation Survey
It is recommended that an initial on sight survey be performed. A method of mounting should
be determined and an installation plan should be reviewed as follows:
 Physical strength of mounting areas should be strong enough to meet or exceed the holding
force of the required Magnalock.
 Placement of the Magnalock wiring and protection from potential damage due to intruders or
vandals external attack should be considered during the survey.
 Accessibility should be considered for prevention of any potential safety hazard.