Manual

- 16D Brushed Chrome
- 16 Bright Chrome
..03 Bright Br.ss
- lOB Oil Rubbed Bronze
The passage codes are stored in adresses "S6 and .57".
The lockout codes are stored in adresses "58. and "59 •.
1. Enter existing program code on the keypad.
1. Press the "E" button.
3. Yellow light on the keypas will flash rapidly
indicating you are in the program mode.
4. Enter two digit prefix for appropriate address.
5. Enter desired code within 5 seconds.
6. When desired code is entered into appropriate
address, wait for red light to flash twice (this
confirms valid entry).
7. Press "E" to exit program mode.
CREATING THE PROGRAM CODE
Password used to change programming
The program code is stored in address "00".
1. Remove the battery access cover.
1. Press "PRGM" button.
3. Yellow light on keypad will flash rapidly indicating you are in the program mode. Once in
the program mode, the yellow light will continue to flash until you exit the program
mode or after a 30 second timeout period.
4. Press "00. for program code address.
5. Enter desired code within 5 seconds. NOTE: Program codes must be 5 - 7 digits long.
6. When desired code is entered, wait for the red light to flash twice (this confirms valid
entry). A fong red flash indicates an error.
SET USER CODES
The SABLuses.m address method to program cmd store codes.
The user codes are stored in addresses "01. - "55".
1. Enter existing program code on the keypad.
1. Press "E" button.
3. Yellow light on keypad will flash rapidly indicating you are in the program mode.
Once in the program mode, the yellow light will continue to flash until you exit the
program mode or after a 30 second timeout period.
4. Press two digit prefix for address
5. Enter desired code within 5 seconds. Note: User codes must be 1- 7 digits long.
6. When desired code is entered into appropriate address, wait for red light to flash twice
(this confirms valid entry).
7. Press "E" to exit program mode.
SmlNG PASSAGE CODES AND LOCKOUT CODES
Released: 6/5/2007
Securitron Magnalock Corp.