Installation Instructions

7
500
-1
0
42
0,
R
e
v
G
Drill the Holes for the Lock Body and Strike Plate
NOTE 1: Figure 6, “Installation
Drill Holes,” provides
illustration for the
following steps.
NOTE 2: Holes #1 and #3 are
1/2” diameter and
1”deep into door.
Hole #2 is 1/2”
diameter and all of the
way through the door.
1. DRILL the three holes for the
installation of the strike plate.
Figure 6. Installation Drill Holes
NOTE 1: Figure 7, “Lock Body
Drill Holes,” provides
illustration for the
following steps.
NOTE 2: Holes A–C are 3/8”
diameter.
NOTE 3: It is recommended to
start drilling with a
smaller bit and then
use a 3/8” bit to not
over size the holes.
2. DRILL the three holes for the
installation of the lock body.
Figure 7. Lock Body Drill Holes