Installation Instructions

4
500
-1
0
42
0,
R
e
v
G
GENERAL
Perform a Product Inventory
1. Upon unpacking this product, PERFORM an inventory to ensure that all of
the required components and hardware have been included; this should
include the items detailed in Figure 1, “Magnalock Inventory.”
Figure 1. Magnalock Inventory
Have the Recommended Tools
1. ENSURE the following recommended tools are available for installation of
the applicable Magnalock:
Power Drill Hammer Wire Strippers/Cutter
1/8”, 3/8”, 1/2” Drill Bits Center Punch Crimp Wire Connectors
Masking Tape Crimp Tool 3/16” Hex Key (Allen Wrench)
Fish Tape or Lead Wire Multimeter 1/2” Open end or Crescent Wrench
Perform a Pre-Installation Survey
NOTE 1: Additional brackets may be needed for proper installation.
Specialized brackets are available through Securitron and its many
product distributors.
NOTE 2: Figure 2, Magnalock Installation on an Out-Swinging Door,” and
Figure 3, “Magnalock Installation on an In-Swinging Door,” illustrate
the typical mounting methods.
1. PERFORM an initial onsite survey to determine a method of mounting and to
review the installation plan, taking the following into consideration:
• Physical strength of mounting areas should be strong enough to meet or
exceed the holding force of the required Magnalock.
• Placement of the Magnalock wiring and protection from potential
damage due to intruders or vandal’s external attack.
Sex Bolt
Magnalock
Strike Plate
Hardware