Installation Instructions

12
500
-1
0
42
0,
R
e
v
G
Install the Magnalock
1. PULL the lock wire into
frame and to desired
location.
Figure 17. Installing the Magnalock
2. APPLY thread lock to
mounting screws.
3. MOUNT lock body to
frame using supplied
hardware (see Figure 17,
“Installing the
Magnalock”).
4. INSERT the tamper finish
caps into the mounting
screw holes (see Figure
18, “Installing the Tamper
Finishing Caps”).
Figure 18. Installing the Tamper Finishing Caps
CAUTION: The Magnalock and strike plate must be in proper alignment or
the BondSTAT and DPS functions will not operate correctly.
NOTE 1: When installing the Magnalock and strike plate, each should be in
proper alignment to the other (see Figure 19, “Magnalock and Strike
Plate Alignment”). This is considered critical for the operation of both
the BondSTAT and DPS. However, there are alignment tolerances for
each model of Magnalock, but these should be viewed as the extreme—
the installation desire is always total alignment.
NOTE 2: The following are the alignment tolerances for the M32, M62, and M82:
Model X-Coordinate
Alignment (+/–)
Y-Coordinate
Alignment (+/–)
M32 B/D 9/32” 1/8”
M62 B/D 5/16” 1/8’
M82 B/D 9/16” 1/8”