Installation Instructions

ManualsBrandsSecuritron ManualsAccess Control Power products10 Amp, 12 VDC Power Supply with Enclosure, 16 outputs, 2 Amp glass fuses

Table Of Contents

500-25015_2

Features

• Small – Light – Efficient – Clean Power

• Field Selectable AC Input: 120/240 VAC

• Tolerates brownout or overvoltage input ± 15% of nominal voltage

• High efficiency: up to 90% at 24V output, full load

• Battery Charger Maximum Charge Current: 1.5A

• Dedicated Constant Current/ Constant Voltage battery charging circuit for

Wet, AGM, and Sealed Lead Acid Batteries

• Power Limited Output with Thermal Protection

• Reverse Battery Protection

• Battery Online, No Drop or Switchover with AC Power Fail

• UL Listed Access Control & Burglar Alarm Systems

• Set of Form “C” Relay Contacts Indicates AC Power Status

• Set of Form “C” Relay Contacts Indicates Low Battery

• Amber LED Indicates Power Normal

• Available Class II Power Limited Outputs

• Lifetime Warranty

Description

The AQS series are heavy-duty, self-contained, efficient, clean, offline switching power supplies, with linear-type performance. The AQS

series have a dedicated lead acid battery(s) charger that obtains maximum battery life while providing 12 VDC or 24 VDC uninterruptible

power for access control security systems. The field selectable AC input on AQS models allows these power supplies to be powered

anywhere in the world. The AQS series have exceptional brownout capability with operation down to 85% of nominal voltage. The AQ series

have an extensive filtering system that provides linear output performance, and they are electronically protected against battery reversal,

shorting, or overloading. All variants are Power limited output with thermal protection when used with a distribution board. Each of these

protective features will self-restore.

NOTE: Before connecting load and battery(s), ensure the 12V/24V jumper is moved to the desired voltage.

CAUTION: Damage can occur when switching the DC output voltage. Proper voltage must be confirmed before connecting devices.

AQS Series 12V or 24V

Power Supply

AQS2410-16C2

Summary of content (4 pages)

PAGE 1
AQS Series 12V or 24V Power Supply Features • • • • • Small – Light – Efficient – Clean Power Field Selectable AC Input: 120/240 VAC Tolerates brownout or overvoltage input ± 15% of nominal voltage High efficiency: up to 90% at 24V output, full load Battery Charger Maximum Charge Current: 1.
PAGE 2
The AQS series are UL Listed and have additional supervisory features: • Battery disconnect relay when battery(s) are depleted • Set of Form “C” relay contacts that indicate AC power failure • Set of Form “C” relay contacts that indicate low battery(s) • Green LED for local “AC” on indication. • DC Output is Class II power limited when used with distribution boards. Note: If no distribution boards are used, Class 1 wiring is required on all outputs.
PAGE 3
Model AQS1210 AQS1216 AQS2410 AQS Supervised Added Features AC Status Output Relay 3Pin Terminal block AC Fail “C” contacts rating 30VDC, 240VAC, 3A, resistive load only Note: AC fail relay is a three position AC fail terminal block marked “NO, C, NC” are shown in the Normal, energized, AC ON condition. Battery LED Indicator Red Battery Max. Charge Voltage (no load) 13.6 VDC Battery Cutoff internal relay contacts 30VDC, 240VAC, 3A, resistive load only Low Battery Cutoff 9 VDC 27.
PAGE 4
AQS in an enclosure with two PDBs in a 24V Configuration Warranty The AQS is covered by the MagnaCare® lifetime replacement no fault warranty. No registration is required. Product will be replaced forever, for any reason, including but not limited to installation error, vandalism, or act of God. Replacement product is shipped at Securitron’s expense next day air, if needed. For more information, visit www.assaabloyesh.