Installation Instructions

Power Supply Settings
The report file sent by email by the Securitron Netlink is sent as an unformatted .CSV file. Many programs,
such as Microsoft Excel, will import a .CSV file to allow viewing of the data. Note that the fields included
will vary depending on the specific system and which parameters are selected on the Reporting page.
The example below has been reformatted for
better readability in Excel. The top three rows
of data give the following basic information:
Site ID
BGO Chicago Office - This is set in the “Site ID” setting
on the Configure Page of the Securitron Netlink
Report Trigger
Report Period - this is a periodic status report.
The frequency of the status reports is set
by the “Send Period” setting in the Email
Settings section of the Configure page.
Service Due
No - The “Next Service Due” date set on the
Configure page has not been reached.
Below the top three rows is data specific to the
Securitron Netlink and any devices connected to it.
Device Name
This column shows which device the associated
parameter belongs to. In this example, the
devices are the Securitron Netlink and FP1.
Device Parameter
This column shows the available parameters which are
being monitored. These parameters vary depending
on the device(s) connected to the Securitron Netlink.
Date/Time Stamp
To the right of the Parameter column are columns
with date/time stamps. These columns are the data,
measured hourly at the dates and times listed. The
number of columns displayed is set by the “Select
Occurrences to Report” setting on the Reporting page.
Tools page example opened in Excel
40