Installation Instructions

Connected
Devices Section
The bottom of the home page shows the devices
connected to the Device connectors of the
Securitron Netlink with a SPI cable. Each device
will display a photo of the device and the model
number. The Device ID is a unique number given
by the Securitron Netlink to each device. The
“Status” indicator shows the current status of the
device. Green indicates a normal state, yellow
indicates a fault, and blue indicates a service item.
A red indicator shows that an FAI request has been
received by the device. Power supplies will also
display the measured output voltage. To access
the page for a device, click either the photo of
the device or the model number. See Accessing &
Programming Connected Devices of this manual
for more information on connected devices.
Accessing & Programming
Connected Devices
When devices are connected to the Securitron
Netlink, detailed information relating to these
devices may be viewed and various parameters
can be programmed through the Securitron
Netlink’s interface. Note that programming these
parameters changes the operation of the device
itself. To access the page for a device, click on the
photo of the device in the Securitron Netlink
Connected Devices section of the home page.
AQL Power Supplies
The Securitron AQL Power Supply page contains
the same Client ID, Site ID, Time, and Date
information as the Home page of the Securitron
Netlink; below that are five main sections.
AQL Device Parameters & History
The section at the top left of the screen
will show the available parameters of
the Securitron AQL Power Supply.
Typical Power Supply Page
34