Quick Start Guide

Stick the adhesive drill template to the
exterior surface of the wall to mark the
desired mounting position.
Drilling and running the power cable
Depending on the mounting surface,
you may require screw anchors.
If using anchors, drill holes at each
of the three outer markers with a
5mm drill bit, then insert the anchors.
Otherwise, if drilling into the surface
directly, drill pilot holes with a 1.5mm
drill bit.
Using a 25mm drill bit, drill a larger
hole in the center of the template.
Drill a hole on the interior side of the
wall and feed the power adapter (or
Ethernet cable for PoE) from the inside,
through the wall and out the hole at
the center of the template.
If feeding the power adapter or Ethernet cable through the wall cavity, using
string or a wire may be helpful to fish the adapter cable though.