UMU OUTDOOR CAMERA Quick Start Guide POWERED BY
Getting to know the camera 12V POWER SOCKET STATUS INDICATOR LENS ETHERNET SOCKET MICROPHONE ADJUSTING NUT STATUS INDICATOR + Flashing blue: the camera is on and ready for Wi-Fi connection + Steady blue: the camera is running properly + Steady red: the camera is starting + Flashing red: there is a network connection issue MicroSD CARD & RESET BUTTON COVER ANTENNA
What’s in the box? 1 OUTDOOR CAMERA 2 POWER ADAPTER 3 SCREWS & ANCHORS 5 DRILL TEMPLATE 6 ANTENNA 4 7 ETHERNET KIT T10 HEX KEY T10
Installation options A Wi-Fi WITH POWER ADAPTER (Recommended) Run the power adapter to a nearby internal power outlet. The camera will communicate over the local Wi-Fi network. You may need the following equipment to extend the range of your power adapter cable (not included): + AC power extension cord OR + 12V DC 5.5mm x 2.1mm power extension cable OR + 18/2 stranded Siamese cable, pigtail connectors OR B POWER OVER ETHERNET (PoE) Power the camera via an Ethernet cable and PoE switch.
Installing the antenna If connecting via Wi-Fi, attach the antenna to the back of the camera, screwing it tightly into position. Installing a MicroSD card (optional) Using the T10 hex key, unscrew the cover on the bottom of the camera. Insert the MicroSD card and replace the cover. The card will be formatted during the add camera process.
Drilling and running the power cable Stick the adhesive drill template to the exterior surface of the wall to mark the desired mounting position. Depending on the mounting surface, you may require screw anchors. If using anchors, drill holes at each of the three outer markers with a 5mm drill bit, then insert the anchors. Otherwise, if drilling into the surface directly, drill pilot holes with a 1.5mm drill bit. Using a 25mm drill bit, drill a larger hole in the center of the template.
Installing the Ethernet kit (PoE only) The Ethernet kit is not required if powering with the 12V power adapter. The Ethernet accessory kit includes a lock nut, a waterproof end-cap, a rubber gasket and an O-gasket. Insert the Ethernet cable through the plastic lock nut and waterproof end-cap. Attach the rubber gasket. Place the thin O-gasket onto the end of the camera Ethernet socket. Connect the Ethernet cable to the camera Ethernet socket.
Mounting and adjusting the camera Push the camera socket cables into the wall through the center template hole. Place the camera into the final mounting position and fasten it securely to the wall with the 3 included mounting screws. Loosen the large adjusting nut at the base of the camera. Adjust the camera to the desired viewing angle, then tighten the adjusting nut to lock the camera in position. Plug the power adapter into the outlet (or Ethernet cable into the PoE switch) to power up the camera.
Resetting the camera If you change your Wi-Fi network or for some other reason you cannot connect to the camera, you will need to reset it. Remove the cover on the bottom of the camera with the T10 hex key, then press and hold the Reset button for 10 seconds. In the app, go to the Settings > Video settings page and select the camera. Update the Wi-Fi settings to re-establish a connection to the camera.
2
