Quick Start Guide

If replacing an existing doorbell, ensure
the AC power is o, then unscrew the
doorbell from the wall. Unscrew the two
terminals to release both wires.
Select the mounting plate that provides
the best viewing angle for the doorbell. If
mounting to an uneven surface use the
included plate foam to remove any gaps
between the mounting plate and wall.
Insert the mini level into the mounting
plate and place the mounting plate on
the wall in the desired location. Mark drill
points on the wall with a pencil.
Mounting the doorbell camera
If mounting the doorbell to a concrete
surface, drill holes into the wall at the
drill points using the included drill bit
then insert the screw anchors.
If mounting to a wooden surface, the
anchors will not be required. Use a
smaller drill bit (not included) to drill
pilot holes directly into the wall.
The bubble on the mini level will be in the center
when the mounting plate is level (vertical).
Fix the mounting plate and optional
plate foam to the wall using the
included mounting screws.
The recommended installation height is 4ft
(1.2m) above the ground.