User Manual

Rev. 20190228A
To Contents 13 of 23
DISABLING THE TIMEOUT LOCK IN ADMIN MODE
Follow the same steps for setting the Timeout Lock (above) and enter 00 for the time
delay. The Timeout Lock will be disabled.
Managing the Drive
The following headings discuss important, though less common, actions for managing
your Drive. Except where noted, all procedures assume your Drive is connected to a
computer and locked (red LED).
Verifying which PINs have Been Set
To determine which PINs have been set up:
Press ; The LEDs display for 10 seconds:
• No PIN exists [ ]
• Only User PIN exists. [ rapidly]
• Only Admin PIN exits. [ rapidly]
• Both PINs exist. [ ]
Deleting all Files in Admin Mode
An Admin operator can delete all data stored on the Drive including User settings and
PIN. All Admin settings (and only the Admin settings) will remain on the Drive. The Drive
will need to be reformatted. For reformatting, refer to Reformatting the SecureDrive on
page 15.
NOTE: All procedures require the Drive to be connected to a computer with the USB
cable.
NOTE: Each step in all procedures listed below have a 10 second window to perform the
next step. In general, a blinking LED times out after 10 seconds.
CAUTION: The ‘Delete All’ procedure deletes all data, User settings, and
formatting. The Drive must be reformatted.
1. With the Drive locked, press and hold down 1-and then press- [ ]
2. Enter the Admin PIN. [ ]
3. Press [ ]
4. Wait for , then press [ ]
5. Press 3,2 (D,A for Delete All) [ ]
6. Press [ alternate ]
7. Enter the Admin PIN again [ alternate ]