User Manual

Rev. 20190228A
To Contents 12 of 23
1. Press and hold down 1-and then press- [ ]
2. Enter the Admin PIN. [ ]
3. Press [ ]
4. Wait for , then press [ ]
5. Press 7,6 (R,O for Read-Only) [ ]
6. Press [ slowly & momentarily, then ]
If successful, the next time the Drive is unlocked it will be in R-O Mode as indicated by
the slow blinking green LED (as well as messages provided by your computer when you
try to save or delete a file).
ENABLING READ/WRITE IN ADMIN MODE
Admin can override a User-set Read-Only state by enabling Read/Write using the Admin
PIN.
Setting to Read-Write does not unlock the drive.
1. Press and hold down 1-and then press- [ ]
2. Enter the Admin PIN. [ ]
3. Press [ ]
4. Wait for , then press [ ]
5. Press 7,9 (R,W for Read/Write) [ ]
6. Press [ slowly & ]
If successful, the next time the Drive is unlocked it will be in R/W Mode as indicated by
the solid green LED.
SETTING THE TIMEOUT LOCK IN ADMIN MODE
To protect against unauthorized access when the Drive is connected to a computer and
unattended, it can be set to automatically lock after a preset amount of time.
In its default state, the Timeout Lock feature is turned off. It can be set to activate (lock
the Drive) any time between 1 and 99 minutes. Admin Timeout Lock settings will override
User settings.
1. Press and hold down 1-and then press- [ ]
2. Enter the Admin PIN. [ ]
3. Press [ ]
4. Wait for , then press [ ]
5. Press 8,5 (T,L for Timeout Lock) [ ]
6. Press [ ]
7. Enter the length of unattended time for Timeout.
Two digits required. [ ] Examples:
01 = 1 minute
99 = 99 minutes
8. Press [ slowly & ]
If successful, the Timeout Lock is now set.