User Manual

Rev. 20190228A
To Contents 11 of 23
5. Enter a new User PIN. [ ]
6. Press [ ]
7. Re-enter the User PIN ]
8. Press [ momentarily, eventually ]
If successful, the User PIN is now added or changed.
LOCKING THE DRIVE IN ADMIN MODE
Locking the Drive without unplugging the USB cable is the same for both modes. Refer to
page 6.
CHANGING THE ADMIN PIN
The Admin PIN cannot be changed from the User mode.
Remember that Press and hold down 1-and then press- means ‘hold down #1
button and press the Key button twice.’
For PIN requirements see page 5.
1. With the locked, press and hold down 1-and then press- [ ]
2. Enter the Admin PIN. [ ]
3. Press [ ]
4. Wait for , then press and hold down 1-and then press- [ ]
5. Enter a new Admin PIN. [ ]
6. Press [ ]
7. Re-enter the Admin PIN [ ]
8. Press [ slowly & , eventually ]
NOTE: If a mistake is made while defining a new Admin PIN or the procedure is not
completed, the Drive retains the old Admin PIN (as well as the old User PIN if one
exists).
Options for Admin Mode
The following headings describe enabling options and features requiring only a User PIN.
This Section:
• Enabling Read-Only in Admin Mode
• Enabling Read/Write in Admin Mode
• Setting the Timeout Lock in User Mode
• Setting the Timeout Lock in Admin
Mode
ENABLING READ-ONLY IN ADMIN MODE
NOTE: When Admin restricts access to Read-Only, the User cannot change this setting.
Setting to Read-Only does not unlock the drive.