User Manual

Rev. 20190228A
To Contents 10 of 23
NOTE: If a mistake was made or the procedure not completed, no Admin PIN will be
created.
CREATING AN ADMIN PIN (USER PIN EXISTS)
The Drive must be locked.
1. Press [ ]
2. Enter the User PIN [ ]
3. Press [ ]
4. Wait for , then press and hold down 1-and then press- [ ]
5. Enter a new Admin PIN. [ ]
6. Press . [ ]
7. Re-enter your new Admin PIN. [ ]
8. Press . [ ]
NOTE: If a mistake was made or procedure not completed, no Admin PIN will be created.
UNLOCKING THE DRIVE IN ADMIN MODE
CAUTION: Possible deletion of all data, settings, and both PINs. After ten
failed attempts to unlock the Drive, it will reset to the blank factory setting.
Refer to Brute Force Hacking Detection on page 14.
1. Press and hold down 1-and then press- [ ]
2. Enter the Admin PIN. [ ]
3. Press [ momentarily, then ]
If unsuccessful [ briefly]
NOTE: If your computer goes into sleep mode while the Drive is unlocked, the Drive may
lock after some time depending on your power management settings regarding
the USB port.
ADDING OR CHANGING A USER PIN IN ADMIN MODE
For PIN requirements refer to page 5.
1. With the Drive locked, press and hold down 1-and then press- [ ]
2. Enter your Admin PIN. [ ]
3. Press [ ]
4. Wait for , then press [ ]