User's Guide
SecureDrive DUO User Guide • 14
20210715
SECTION 4: BASIC COMMANDS
Below are keypad codes and app functions that detail how to perform basic commands on the
Drive. Alongside the keypad commands are the LED indicators displayed on the Drive that show
the code was entered properly. Often, when proceeding to the next step after pressing the
LED display remains the same as the previous step.
The Drive includes Bluetooth, which it uses to communicate with the mobile app. In some
situations, you may not be able to use Bluetooth or wish to disable it. Even after disabling
Bluetooth you may enable it again through the keypad.
By default, Bluetooth is already active. To disable this feature, follow these steps:
Once disabled, you may reactivate the Bluetooth feature. To enable it again, follow these steps:
If you are uncertain if Bluetooth has been enabled or disabled, using the keypad you may enter a
command to check. To see its status on the Drive, follow these steps:
To cancel most procedures prior to finishing the input on the keypad, press and hold
for six
seconds. You may also let the Drive time-out after 10 seconds.
1. Press
.
2. Enter User Password.
3. Press
. ,
4. Enter 728.
5. Press .
6. If Bluetooth is currently enabled, you will see
, five times. If it is disabled, you will
see
, five times.
1. Press
.
2. Enter User Password.
3. Press
. ,
4. Enter 281.
5. Press .
6. If successful, you will see
, five times; if the command failed, you will see ,
five times.
1. Press
.
2. Enter User Password.
3. Press
. ,
4. Enter 280.
5. Press .
6. If successful, you will see
, five times; if the command failed, you will see ,
five times.
Bluetooth Feature and Status
Cancelling a Procedure