User's Guide

9
ReliAlert™ Hardware
Offender Phone Calls
Offender Phone Calls
The ReliAlert™ can initiate and receive voice communication via the following:
• Call Button – Used to initiate or cancel outbound calls to the Monitoring Center
• Speaker Ring Tone / Vibrate – For incoming calls, the device vibrates for 5 seconds
and also generates a ring tone. The device will automatically answer the call.
Calling the Monitoring Center
To initiate a voice call from device to the monitoring center:
1. Press the Call Button for five seconds.
2. Release the button when you hear two short audio tones.
To cancel a device-initiated voice call:
1. Press the Call Button for approximately five seconds until you hear two short audio
tones.
Note: This feature is only available when the call was initiated by the offender. The
offender cannot disconnect a call initiated by the Monitoring Center.
Call Button