User's Guide

ReliAlert™ Hardware

Internal Battery Charger

A fully charged internal battery will provide over 24 hours of operation. Under typical use the

internal battery is 90% charged after charging for 60 minutes. However, it takes approximately

2 hours to optimally condition the charge on the internal battery.

To charge an internal battery:

1. Make sure the 12 volt wall adapter is connected to the device and the other end is

plugged into the break-away cable. To plug in the adapter to the device, connect it to

the open connection on the front of the device.

2. Plug the wa

ll adapter into a power outlet.

3. Make sure that the “charging LED” illuminates on the device. The Green LED will

only show after the device has been powered up.

Note: While device is connected to wall adapter a double green flash every 1 second of

the LED indicator reflects that the internal battery is charging. A solid green light

indicates the internal battery is fully charged. Following 3 hours of displaying a solid

green, the LED indicator will return to the normal operation of a single green flash

every 5 seconds. To confirm that battery is indeed fully charged, simply disconnect

the power connector from the device and reinsert and then wait for 5 seconds, if

fully charged the LED will show solid Green.