User's Guide

ManualsBrandsSecureAlert ManualsElectronicsOffender Tracking Device (OTD)

ReliAlert™

User Guide

Obstacles disappear with ReliAlert™’s House

Arrest feature. Utilizing SecureAlert’s beacon

technology, the ReliAlert™ and our tamper-

resistant transmitter, elevate SecureAlert’s

tracking capabilities to new heights. Whether

the oender lives in a basement or works

downtown, our House Arrest feature allows

ocers to tether an oender to any location.

Summary of content (12 pages)

PAGE 1
Obstacles disappear with ReliAlert™’s House Arrest feature. Utilizing SecureAlert’s beacon technology, the ReliAlert™ and our tamperresistant transmitter, elevate SecureAlert’s tracking capabilities to new heights. Whether the offender lives in a basement or works downtown, our House Arrest feature allows officers to tether an offender to any location.
PAGE 2
.
PAGE 3
Introduction Introduction In addition to current methods of monitoring offenders through ReliAlert™ and GPS tracking, SecureAlert ‘s new product the eArrest Beacon and ReliAlert™ will provide agencies with significant advantages.
PAGE 4
.
PAGE 5
ReliAlert™ Hardware
PAGE 6
ReliAlert™ Hardware ReliAlert™ Highlights R eliAlert™ Highlights • Single unit device with active GPS monitoring supported by SecureAlert’s 24x7 Monitoring Center • Capable of secured local Radio Frequency (RF) Communication • Two/Three-Way Communication allows: • Instant intervention by SecureAlert’s Monitoring Center via voice communication directly to the ReliAlert™ device • Supervision Officers the ability to communicate with an offender via the device • Internal battery allowing the ReliAler
PAGE 7
ReliAlert ™ Hardware ReliAlert™ Highlights Voice Communication Communication to the device can only be made from the Monitoring Center. All other phone numbers are blocked to the ReliAlert™ device. Outgoing voice calls from the ReliAlert™ device are to a predefined number into the Monitoring Center. All calls to and from the monitoring center are digitally recorded and can be retrieved by request. Voice quality on the device is subject to the same limitations as a standard cellular call.
PAGE 8
ReliAlert™ Hardware ReliAlert™ Device Interface ReliAlert™ Device Interface Indicator LED Green, amber or red Call Button Initiates and disconnects outbound calls and powers up the device Vibration Feature Inside the device Speaker Under shield at the front of the device Microphone Bottom-left corner on front of the device Internal Battery Located on the bottom of the device 6 C a ll B u t t o n L E D In d ic a t o r
PAGE 9
ReliAlert™ Hardware ReliAlert™ Device Power-Up ReliAlert™ Device Power-Up Prior to the device power-up sequence, the 12 volt AC adapter must be plugged into the device for two hours. This will charge the internal battery. A fully charged internal battery will provide over 24 hours of usage. To power-up the device: 1. Press and hold the Call Button. The Indicator LED illuminates and an audio tone is heard after approximately five seconds. C a ll B u t t o n L E D In d ic a t o r 2.
PAGE 10
ReliAlert™ Hardware Internal Battery Charger Internal Battery Charger A fully charged internal battery will provide over 24 hours of operation. Under typical use the internal battery is 90% charged after charging for 60 minutes. However, it takes approximately 2 hours to optimally condition the charge on the internal battery. To charge an internal battery: 1. Make sure the 12 volt wall adapter is connected to the device and the other end is plugged into the break-away cable.
PAGE 11
ReliAlert™ Hardware Offender Phone Calls Offender Phone Calls The ReliAlert™ can initiate and receive voice communication via the following: C a ll B u t t o n • Call Button – Used to initiate or cancel outbound calls to the Monitoring Center • Speaker Ring Tone / Vibrate – For incoming calls, the device vibrates for 5 seconds and also generates a ring tone. The device will automatically answer the call. Calling the Monitoring Center To initiate a voice call from device to the monitoring center: 1.
PAGE 12