User Manual

TrackerPAL™ Operations Guide

RemoteMDx, Inc.

Page 15

3.4.3 Answer an Incoming Voice Call

Usage: Answer and Call Center Initated Voice Call

1) Incoming call occurs

2) Unit will indicate incoming call: Vibrator will activate, Ring tone will occur, Call Status will flash

quickly

3) Press and hold Call Button for approximately 1 second

4) Call Status LED will flash 3 times very quickly to indicate button press recognized

5) Call Status LED will flash 3 times very quickly to indicate event accepted

6) Vibrator and ring tone will stop

7) Call Status LED will go solid on to indicate call in progress

NOTES:

The unit is only able to make calls while the unit is registered on the cellular network (the same as a regular cell

phone). The “waterfall down” ring tone indicates that registration has occured (ring tone may be disabled).

Incoming calls to the unit may be initiated from any telephone number. (Call screening may be enabled to

prevent unauthorized usage).

An incoming call is indicated simultaneously by a periodic ring sound emitted by the speaker and periodic

activation of the vibration motor.

4.6 Remotely Generated Alerts

Alerts can be generated and sent to the unit through the selected gateway's website. The possibilities include

an audible alert event, which causes a short ring tone to be played through the speaker, and a vibrate alert

event, which causes the vibrator motor to vibrate in a set of bursts. No user response to these events is

required, though the unit does acknowledge to the website that it has received and processed these alerts.

4.7 GeoZones

All required GeoZone functionality and support has been implemented. Please refer to Device Gateway

Reference Guide for further information.

4.8 Diagnostics Mode

A simple diagnostics mode has been implemented to indicate the current state of the unit. This is a special

mode intended for field testing and is disabled by default.