User Manual

TrackerPAL™ Operations Guide RemoteMDx, Inc.
Copyright © 2006 RemoteMDx, Inc.
All rights reserved.
Page 14
“Regular” ring tone alert on incoming call
3.4.2 Configurable System Default Values
Primary Call Center Number: SecureAlert specified number
Secondary Call Center Number: SecureAlert specified number
Incoming Call Auto Answer timeout: 5 seconds
Outgoing Call timeout: 20 seconds
3.4.3 Initiate a Voice Call
Usage: Initiate a voice call from unit to the call center
1) Ensure unit is operational and registered on the GSM network
2) Press and hold Call Button for approx. 5 seconds (between 3 to 8 seconds accepted)
3) Call Status LED will blink 3 times very quickly to indicate button press has been acknowledged
4) Release Call Button
5) Call Status LED will blink 3 times very quickly to indicate command has been acknowledged
6) Call Status LED will begin to blink slowly to indicate it is initiating an outbound call
7) When call is answered at call center, Call Status LED will change to solid on
NOTES:
1) If the outgoing call to the first call center number is not answered within a configurable amount
of time, the unit will hangup, pause 5 seconds, and then try the second call center number.
2) If the second call center number is not answered in within the same configurable amount of
time, the unit will hangup.
3.4.2 Cancel a Unit Initiated Voice Call
Usage: Cancel a call if there is no answer at the remote end (phone rings indefinitely) or
unit connects to machine which leaves it connected indefinitely.
1) Press and hold Call Button for approx. 5 seconds
2) Call Status LED will blink 3 times very quickly to indicate button press has been acknowledged
3) Release Call Button
4) Call Status LED will blink 3 times very quickly to indicate command has been acknowledged
5) Unit will hangup and Call Status LED will go off